Laboratory UV Lamp Stand for Vilber-Lourmat VL-6LC
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An enclosed stand for the Vilber-Lourmat VL-6LC UV lamp used for TLC plate analysis in synthetic organic chemistry labs.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 219
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Chemistry & Biology
- Licencja
- Creative Commons — Attribution — Noncommercial
We needed a proper stand for the UV lamp we use in our lab to analyze TLC plates because of safety concerns with a homemade cardboard box. A commercial stand can be quite expensive and it does not provide a real cover to minimize exposure to UV light sometimes. Therefore, we have designed a suitable stand for our UV lamp (Vilber-Lourmat VL-6LC) with the following features:
- An enclosure around the UV lamp with an opening for analyzing TLC plates.
- Fixture for the UV lamp to prevent the instrument from tipping over
- A detachable safeguard that can prevent the UV lamp from being lifted, as requested by our safety staff (If this is not necessary for you, simply do not print the guard, as nothing else will be affected by omitting this piece).
We printed the stand in LUVOCOM 3F PAHT CF 9891 BK from LEHVOSS because the UV lamp can get quite hot and PA6 CF can withstand higher temperatures. In any case, it is strongly recommended to use a material with a reasonable temperature resistance as a safety measure.
Our print settings were:
- material: LUVOCOM 3F PAHT CF 9891 BK
- nozzle diameter: 0.6 mm (abrasion resistant with a ruby tip)
- layer height: 0.3 mm
- line width: 0.58 mm
- wall thickness: 1.16 mm
- top/bottom thickness: 1.2 mm
- infill: 25 % octet
- printing temp.: 270 °C
- fan speed: 50 %
- build plate: carbon fiber surface + Dimafix
- build plate temp.: 80 °C
- Print speed:
- infill = 40 mm/s
- outer wall = 25 mm/s
- inner wall = 30 mm/s
- top/bottom = 25 mm/s
- supports are only required for the detachable safeguard
- brim: 7 mm
The following part orientation was used:
![]() | ![]() |
The stand was assembled using the two-component UHU Turbo Fix² for plastics. The six parts of the stand that hold the lamp in place should fit tightly into the corresponding anchor points so that no clamps are needed for the gluing process. Paper clips (larger than the white one shown for the detachable safeguard) or small clamps can be used to glue the box and front opening cover together.
Depending on the filament you are using, some filing may be necessary to get the attachments to fit properly. We had this problem for the stand printed in PA6 CF, while the parts fit properly without filing for all prototypes printed in PLA. We have added alternative versions of the attachable parts so that you can choose the clearance that works best for your material and printer.
We hope you will like this tool if you are looking for a proper stand for the Vilber-Lourmat VL-6LC UV lamp. A stand for another UV lamp model that is used a lot in our department will follow in the future.

