Sakura Short Dart Blaster

This is  Sakura.

theres a lot of features that this blaster can offer, such as being able to go from ~150 fps up to ~250 fps on a single spring and barrel combo (SF-25 and 40CM Kury barrel) using only spacers! And that can obviously go higher or lower depending on s-b combo. ive found the prime at 250 fps to actually be much smoother than my old 175 fps K25 T4, and at the same time, this blaster also has a slightly longer draw than the T4 (coming in at 4.5" or 114mm), which is why it's capable of using a 40cm barrel. this blaster also has a stupid light and crisp trigger release with no tolerance for wiggle, and is extremely comfortable with a non-offensive grip and HK-styled stock. unfortunately, i didnt design this blaster with a bearing prime system or twist collet muzzle in mind, but don't worry, the V2 will have all those fun little features everyone wants and more.

This blaster has been in the making for about 5 months now, and I'm finally done tweaking stuff and ready to see what the community does with it.

---------------------------------------------------------------------------------------------------------------

Pretty much every part can be printed at about 20% infill with 4-6 walls (I did 15% with 3 walls, but it's better to overbuild something so it won't break), and you wont have any issues, I definitely recommend printing the stock with higher infill and more walls for safety reasons, and your printer will need to be able to detect and print thin walls. everything should be oriented properly but i recommend taking a couple seconds in your slicer to make sure everything is flat on the plate. (as of right now, this requires a ender sized print volume)

As for hardware, for most of this build, you can recycle a Talon Claw V4 hardware kit for most of it.

 you will not need the metal ram, any elastics or extension springs, any 4-40 standoffs, the -012 o-rings, the TC-sized spring, or the small rubber grommet. 

you will need two -016 o-rings, two -014 o-rings, one 6x7mm ball detent (like for lynx 2.1), one .25x.375" compression spring, one .25x.625(or .75)" compression spring, one ~5.75" 10-32 threaded rod, a .25" - .375" long takedown pin, and one Caliburn length (11") spring.

---------------------------------------------------------------------------------------------------------------

### UPDATES ###

1.1 - Some Parts have been changed to a 1.1 version, these parts simply include quality of life changes, or some simple geometry changes to allow parts to fit together nicer.

these include loosened tolerances for certain through holes, moving of a rear screw point to allow toolless disassembly for spring swaps and maintenance, and loosened tolerances for the nut that holds the threaded rod through the stock (previously required to be heat-set into the stock or modified because it was too tight). the old versions of these parts WILL STILL WORK FINE, but these just allow for cleaner assembly and easier disassembly.

Added 1.1 Buttplates, looser dovetails as well as a medium and long length, for the lads with a larger wingspan.

1.1 Upper Magwell, added a second smaller hole to the top, use a 4-40 to secure the rear flatbar into place through this hole, this was a design oversight on my part.

---------------------------------------------------------------------------------------------------------------

BUILD GUIDE 👇👇👇

if you want to sell this blaster, a version of it, or hardware for it, just shoot me a message and we can talk abt it.

---------------------------------------------------------------------------------------------------------------

anyways, .stp files will be linked once i figure out how, but the models aren't necessarily pretty so good luck with all that if you wanna modify them lol. keep in mind, this is my first blaster design, so i need to learn how to make my models a bit cleaner and more accurate.