Tesla Model Y Wheel Cover Hub Cap Center Logo
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement for the wheel cover center provided by Tesla and other vendors.
- Ocena
- 0 / 5
- Polubienia
- 26
- Pobrania
- 132
- Wydruki
- 0
- Wyświetlenia
- 1423
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Introduction and Use Case
This is a replacement for the wheel cover center provided by Tesla and other vendors for Tesla Model Y and perhaps other Tesla models.
Printing
I printed with two colors using PETG filament and began with yellow. I switched filament colors after 5.44 mm. I used variable layer height on the automatic settings with the minimum height set to 0.05 mm (Ultra-detail). You can, of course, use a different layer height but this setting printed very well for me.
Since I printed from the bottom up and the center is hollow, I used supports on the build plate only with a “grid” style of support and a top contact Z distance of 0.2mm (detachable). This worked quite well and the support came off quite easily. Beyond removal of the support, there was no post-print processing required.
Installation
Installation requires use of 2 inch diameter 3M VHB Mounting Pad Stickers

which can be purchased on Amazon at https://amazon.com/dp/B0C6QZZKJD
Results are excellent.
