ARTME3D MK3 cheapass filament gauge
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A cheap gauge for filament diameter. Somewhat accurate, good enough maybe
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 446
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Update 17/01/2025:
- added 1.35mm mark to gauge. Also test sticks model updated
- slightly reinforced version of the pu_b_gauge part
- bearingless arms. Untested! But should work work with M3 screws alone. Make sure the parts rotate freely.
So 34 eur for proper precision gauge was too much for me (at least for now) so I decided to try and make a low cost version. Seems to work well enough.
Uses 3 623zz bearings. Needs 3x ~10mm M3 screws and a couple of M3 washers for the arm assembly and 2x M4 screws and 2x M4 nuts for mounting. The T-nut model is provided.
Just print the parts and assembly should be straightforward.
Calibration: there's a test sticks-model for 2mm, 1.75mm and 1.5mm, use those to calibrate. Move the gauge part around until the arm is shows proper value and then tighten the screws.
OpenSCAD source here: https://github.com/spegelius/3DModels/tree/master/ARTME_3D_Filament_Extruder_remix