BTT-pi TFT43 mount for clicky-clack door + doorbuffer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement mount for the BTT-pi TFT43 touchscreen which protrudes 2cm further than the stock "thick" one.
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 66
- Wydruki
- 1
- Wyświetlenia
- 391
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
The LDO voron kit comes with a BTT-pi TFT43 touchscreen and a mount for it.
With a 2cm-thick clicky-clack door, the screen needs a deeper mount - this is the stock “thick” mount (and the model by rchamp uses the same depth, but adds a nice slope on the top to make it easier to close the door).
But with a doorbuffer on top of that, it goes 2cm further, and that “thick” mount is no longer thick enough.
Enters this remix: it further extends the mount by 2cm to keep the screen in a comfortable location.
Print on its back. Should be fine without supports.
It won't be exposed to high temperature, only light pressure when you're using the touchscreen. I used ASA but any material would be fine. I used a 0.4mm nozzle (there are a few thin walls and this helps), 0.2mm layers (for nice smooth curves), 3 perimeters and 12% gyroid infill.
You'll need an allen key long enough to tighten the screws through the longer holes now, but it shouldn't be too hard.
This was designed on onshape: onshape link.