Elecraft KX3 battery mod / Li-ion 18650 cell
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Convert your Elecraft KX3 internal batteries from NiMH to Li-ion 18650 cells.
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 76
- Wydruki
- 0
- Wyświetlenia
- 717
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
If you want to use Li-ion 18650 battery (like original KXBT2) internal in your Elecraft KX3 instead of NiMH batteries, you will need this new holder and retainer.
Material
PETG or better
Layer height
≤0,2 mm
Infill
100%
Support
None. The model was designed not to require any support material.
Description for mod:
-remove the 2 battery holder and battery retainer or internal NiMH Charger /Real-Time Clock
-use the 4 old screw from the holder and retainer for the new one
-glue a piece of aluminium tape on the new retainer (64 x 50mm)
-Cut a 4mm hole in the aluminum strip where the 3mm hole is
-For easy use and charging the battery, build a two-pin cable (0,5 qmm) with a DC plug (male) and socket (female) 5.5 x 2.1 mm. Insert the cable through the existing power socket on your KX3. You don't have to drill anything, etc. Use cables with good insulation and additional shrink tubing.
Diese Anleitung ist nach bestem Wissen und Gewissen erstellt und kann Fehler enthalten. Das Nachbauen sollte nur von fachkundigen Personen durchgeführt werden und diese handeln eigenverantwortlich. Für Schäden an Gegenständen oder Personen übernehme ich keine Haftung!
These instructions have been created to the best of our knowledge and belief and may contain errors. The reconstruction should only be carried out by specialists and they act on their own responsibility. I assume no liability for damage to objects or people!