Gummy Latch for BRS Replicant
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fix up your latchless Replicant (or clone) with this TPU holder-shutterer.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 280
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Your Replicant, or clone thereof, is a high speed/low drag piece of kit, innit? So low drag, it shows up without a latch.
Sure, you could carry it around in the little nylon belt pouch it came with like some kind of goober. Or you could latch it right back up with this.
Obviously, you'll want to print this out of TPU. I find that 100% infill works best. The thick side ought to be a nice tight friction fit over most of the available scale options, and the thin side will be a little looser so's you can easily push it out of the way with your pinky and get to flippin'. If you need to tune the fitment, I'm sure you could scale it in your slicer by a percentage point or two.