Simple Halloween Eyeball (Single Extruder - Multicolor Print)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Halloween Decoration: A simple eyeball made of three parts that can be printed in different colors.
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 104
- Wydruki
- 0
- Wyświetlenia
- 426
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Share Alike
The model is a very simple eyeball made up of the three components:
- Eyeball
- Iris
- Pupil
All printed in different colors can simply be put together and can be used as a nice Halloween decoration.
The three parts can be glued together, but they don't have to: they already hold well when they are inserted into each other.
*****************************************************************
I'm still a beginner and I'm testing with the modelling and print settings.
I have successfully used the following for this simple model:
My photographed example is printed with different PLA (esun / eryone).
I only used supports on the print bed and activated the edge for a better grip on the print bed.
I left everything else in the standard Prusa profile 0.20 STRUCTURAL.
Experiment with Infill: To low is not good for combine the Parts.
| My Test-Print: | ||
 | Single Extruder PLA Milky White (esun) 0.2 STRUCTURAL Generic PLA 0.4 Noozle with IS Eyeball about 50 Minutes Reducing to 5% Infill is possible but tricky to combine the three parts. 10-15% would be better. (The light point can break) | |
 | My first test print - Next time I will orient the pressure differently, because I didn't get the supports nicely from the iris as you can see :D
Better way for Iris an Pupil: Better result with this orientation:  |
