Handle for Sliding Door Ducato/Jumper/Boxer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Larger handle for the inside of the sliding door of a Ducato/Jumper/Boxer panel van.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 111
- Wydruki
- 0
- Wyświetlenia
- 537
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
I recently converted a standard empty Citroën Jumper panel van to an RV. After insulating the sliding door, the standard handle did not fit anymore, as it leaves not enough clearance between door and handle.
The handle was designed to somewhat fit the original from a design perspective but leave more clearance to the door to allow for insulation. It also is a bit longer to get a better grip. See the images where my design is next to the original.
There are two options for printing. The model named _Split is split into 3 pieces to allow printing in the optimal orientation for each section and without support. This however then needs to be glued and assembled. The other model is for printing in one piece. These two slicing options are also shown on the pictures.
I printed mine with PETG-CF and 6 perimeters. This seems pretty strong. Pure PETG would probably have been sufficient as well.
As I increased the distance to the door, I needed a longer screw. I used a 40mm M6 machine screw.