CB3SBracket

I'm a happy user of @Stephenlofgren's TYWE3S jig.

Since the carrier board dimensions for the CB3S are identical, I thought I could get away with using it to flash OpenBK onto a Xenon SM-SO301U power strip. After alot of fiddling and frustration I realized that the RF shield on the CB3S is narrower and the TYWE3S jig wasn't lining up on the pins.

I don't really know how to use FreeCAD (I'm a CadQuery user) very well but after some exploring @Stephenlofgren's params table I managed to:

• change chipx from 13.50mm to 11.80mm;
• change pinrowwidth from 15.00mm to 15.40mm;
• [this also changes the bracketx dimension]; and
• export an STL file.

This gives a snug fit on the chip. It's still a bit fiddly, it can take a try or two to get it in the right place, but it worked for two separate power strips.

I'm using the same pogo pins as the original model: https://www.amazon.com/gp/product/B007Q8JILQ

I use the "1.0mm" bit from this set, https://www.amazon.com/gp/product/B0C46BPQ53, to clear the holes, reaming them out until I can push the pin in with fingernails and/or a needle driver. The bit measures something like 0.85mm.

I printed the jig on a Prusa Mini using Prusament PETG filament using the included G-code file.

Print Settings

Printer Brand:

Prusa

Printer:

**Rafts:**

Doesn't Matter

Supports:

**Resolution:**

0.20mm Quality

Infill:

**Filament:** Prusament PETG Yellow

Notes:

Post-Printing =============

Category: Electronics