BigBox Z-Axis Bed IR Sensor Mount.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an alternative to mounting the IR Sensor to the Printhead.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 311
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This is an alternative to mounting the IR Sensor to the Printhead. Simply replace one of the Z-Axis Drives Supports with this, wire in the IR Sensor Cable through the Heated-Bed Drag Chain, Affix the IR Sensor to the mount, bolt the two together and away you go.
Perfect if you just want to use Mesh Leveling as it will give a consistent reading.
Position the IR Sensor facing upwards towards the Upper Support.
Print with your favourite thermoplastic | http://e3d-online.com/All-Filament
Requires |
2 x M3 12mm Screws (Bag 9).
2 x M3 Square Nuts (Bag 6).
2 x M2.5 6mm Screws (Bag 5).
2 x M2.5 Square Nuts (Bag 4).
*This is untested so any feedback would be great :)
Updates
10-01-17 | Lengthened IR Mount to allow for Volcano.
14-06-16 | Altered to lift the sensor up higher.
27-05-16 | Added STP file.
Love 3D printing? Love T-Shirts?
Then you need to check out steps-per-mm.xyz!
It is loaded with a huge range of wearable Parts & Components.
Please help support my work here on Thingiverse and on Instructables by using the following affiliate links when making purchases. Thanks :)
eBay.com | eBay.co.uk | eBay.fr | Amazon.co.uk
Print instructions
Category: 3D Printer Accessories Print Settings
Printer: BigBox
Rafts: No
Supports: No
Resolution: 0.25mm
Infill: 20%
Notes:
Print with E3D's Edge ;)