Porsche 997 Air Vent Slider
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A fix for Porsche 997s with a broken air vent slider that doesn't control left and right movement.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 76
- Wydruki
- 0
- Wyświetlenia
- 369
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model is for Porsche 997s whose air vent slider is broken i.e. moving left and right doesn't work. This simply slides onto the back of the existing slider and aligns with the existing air vent slat to control side to side movement.
You'll need to pull out the air vent to put on the slider, and I recommend using long needle nose pliers to grab onto the part to fanagle it onto the slider. The part is designed to slip through the air vents and have the pliers control the attachment to the slider. I used 3M Automotive Trim double sided tape on the inside of the part to make sure it stays on.
- I printed this with ASA and didn't have any issues with shrinking; PLA most likely wouldn't work in a car environment as it can get hot inside
- I printed with the triangle facing up, with this setup make sure to add a brim so that the part sticks to the bed. I used a Bambu P1S with the default outer brim settings.
This is my first public model so I'm open to suggestions!