Sunlu filament dryer S2 roller arm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This roller arm is for the filament to smoothly slide out of the dryer at a 90 degree angle to the printer
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 306
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This roller arm is for the filament to smoothly slide out of the dryer at a 90 degree angle to the printer without excess rubbing on the PTFE tubing, which without the roller found created a lot of friction and caused problems during printing.
Needed:
Ball bearing with 8mm inner diameter
M8 bolt and nut
Note: I printed the wheel in half with pins for the ball bearing to sit nicely inside, then glued using epoxy to be held together strongly.
For mounting onto the dryer I used 3m double sided heavy duty tape.
Recommended print settings:
>25% infill