SpoolWorks Scaffold Soluble Support Spool Carrier

This is a Spool Carrier designed specifically to fit inside the airtight bag used to store E3D's SpoolWorks Scaffold Soluble Support. It will work with all SpoolWorks 200mm Spools (500g/750g) . Supports both 2.85mm & 1.75mm filament.

Read the Fulll, detailed, blog post about E3D's Scaffold at | Scaffold Blog Post.

Print with your favourite thermoplastic | http://e3d-online.com/All-Filament

Consider the Heavy-Duty Air-Tight Filament Spool Case as an alternative.

2 x 608ZZ Bearings.
1 x 1.75mm or 2.85mm Thread Bowden Coupling.
1 x Matched Length of PTFE.
6 x M3 10mm Socket Cap Screws.
6 x M3 Hex nuts.
1 x M8 50mm Socket Cap Screw.
1 x M8 Hex Half Nut.
1 x M8 Washer.
1 x Rubber O-Ring 10mm ID x 2.5mm.

Love 3D printing? Love T-Shirts?

Then you need to check out steps-per-mm.xyz!

It is loaded with a huge range of wearable Parts & Components.

Please help support my work here on Thingiverse and on Instructables by using the following affiliate links when making purchases. Thanks :)

eBay.com | eBay.co.uk | eBay.fr | Amazon.co.uk

Print instructions

Category: 3D Printer Accessories Print Settings

Printer: E3D's BigBox

Rafts: No

Supports: No

Resolution: 0.25mm

Infill: 15%

Post-Printing

Using the Carrier

Slide the spool onto the carrier and load it into the bag making sure the hole for the bowden coupling is facing towards the bag's opening.

Guestimate an approximate place in the bag where it aligns with the hole for the bowden coupling and make a small cut in the bag.

Fit the optional O-Ring over the threaded section of the bowden coupling. Screw the coupling into the hole ensuring a good seal.

Attach your PTFE to the coupling, feed in some Scaffold and then seal up the bag. Remember to leave the included packet of silica gel in the bag.

You're all set!

Happy Printing :)