Olight and Fossil Watch Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A bedside charging station for an Olight SRII Baton (or similar) and a Fossil watch.
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 37
- Wydruki
- 1
- Wyświetlenia
- 563
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Public Domain
This is a design to charge both my EDC flashlight (an SRII Baton from Olight) and my watch (a Fossil Gen4).
I printed it in PLA on a Prusa i3 Mk3, with four walls. In order to build this, you will need to first install the charging puck for the watch into the holder. It is a friction fit. If it does not friction fit, a little hot glue underneath. This then slots into the base, and can be glue with more hot glue.
After the watch stand and base are glued, run the flashlight charger and glue in place with, you guessed it, more hot glue.
After using this for a little, I added a rubber foot with hot glue. It keeps the whole thing from sliding around.
Future improvement ideas:
- A PCB to connect all the cords into one outgoing cord.
- A weighted base to further help with sliding.