Milescraft Track Saw Guide Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sturdy mount for Milescraft track saw guide rails. Use a pair to hang a rail on the wall, garage door, etc.
- Ocena
- 5 / 5
- Polubienia
- 31
- Pobrania
- 179
- Wydruki
- 4
- Wyświetlenia
- 787
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
Pretty self-explanatory. Print one base and one nut in the default STL orientations (flat for the nut and on the side for the base). This will give the best strength and will require no supports.
Assemble base to nut with one M6 x 20mm hex bolt and nut. You can play with the orientation of the M6 nut and/or bolt to insure that it is "tight" when the holder's nut is in the down/locked position.
Designed to use a pair of 1-1/4" pocket hole screws for mounting, though obviously any similar flat-bottom screw will do.
I suggest ABS, PETG, or other more structurally sound filament. I printed these with PETG using a 4mm nozzle at 0.28mm layer height and 3 walls, but the original was printed with a 6mm nozzle, which is probably a better choice if you have one.