1 / 5
BentoBox Duct Base for Prusa MINI Official Enclosure — zdjęcie 1
1 / 5

BentoBox Duct Base for Prusa MINI Official Enclosure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a remix of the BentoBox duct. Attaches to the octagonal cutout at the rear of the Official Prusa MINI enclosure.

Ocena
0 / 5
Polubienia
6
Pobrania
23
Wydruki
0
Wyświetlenia
283
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This replaces the original BentoBox duct to fit the Official Prusa MINI Enclosure.  Compatible with the rest of the BentoBox v2.0 parts.

Printing
Print the duct in the default orientation (standing up).
Print the mounting plate laying flat on your print bed.

Assembly
-Use some side cutters to remove the octagonal cutout at the back of your MINI enclosure.
-Insert 4 M3x5 heatset inserts into the holes on the back of the duct.
-Place the duct inside your enclosure and align it with the cutout.
-From the outside of the enclosure, place the Mounting Plate onto the octagon on the back of the duct and secure it with 4 M3x8 bolts.  Be careful to NOT over tighten the screws.

**Before printing with your MINI, check the clearance of your bed heater cables and ensure that they are not getting crushed against the BentoBox duct.  If it's too close for comfort, I recommend a different cable mount, such as this one by Waschtl.**

Tagi