Brady TLS2200 Battery to DC Adapter/Converter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A battery adapter that allows you to use the TLS2200 on DC Power
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 97
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My father's Brady TLS2200 is the label maker he has used for 20+ years. He has built up a good collection of labels and ribbons for it. They no longer make the labels for it and haven't for years, but even if you have the labels for it, the batteries are $150 a pop, and only last so long. If the battery goes dead, you can not use the label maker.
I modeled up the battery box, and have added a DC port to it, to allow you to use the label maker on DC power.
This is made to use the original PCB inside the battery, so you do not have to provide your own contacts, or switch. I cut open the plastic holder for the batteries using a bandsaw and a very light touch.
NOT: Be very careful when cutting open the battery I am not responsible for any injury you may cause yourself or others, as a result of wanting to do this print and salvage the PCB.
Print Settings:
Supports: On for both the top and bottom half.
Material: PLA is fine.
Parts Needed:
(1) Salvaged PCB from a old TLS2200 Battery
(4) M4x6mm Heat Inserts
(4) M4 x 12mm SHCS
(1) 5.5 x 2.1 Barrel Panel Mount Plug. I ordered these from Amazon
(2) Pieces of 18 Gauge Wire
(1) DC Power Source of 7.2 - 9V. 5amps is required, or you get a low battery alert. I purchased this one.
