1 / 3
Ender 3 V3 SE/KE Dampening Noise Reduction Anti-Vibration Feet — zdjęcie 1
1 / 3

Ender 3 V3 SE/KE Dampening Noise Reduction Anti-Vibration Feet

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Noise-Reducing Anti-Vibration Feet

Ocena
5 / 5
Polubienia
347
Pobrania
1493
Wydruki
7
Wyświetlenia
7604
Oceny
5

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This design is specifically aimed at reducing vibrations on the Y-axis, particularly the bed, which carries the most inertia and tends to resonate at higher harmonic frequencies. In my tests using Klipper and an ADXL345 sensor, I've been able to achieve higher accelerations thanks to these feet, making them a crucial upgrade for 3D printers.

You will need to print two front feet and two rear feet. One of the rear feet must be mirrored in the slicer to ensure the cutout aligns properly with the bump on the printer's base. Recomended orientation and supports placemente in photos.

I printed these feet in PLA at a layer height of 0.32 mm, with 4 walls and 30% infill. I attached them using the thinnest double-sided tape I could find, but any kind should work fine. I've been using them for several months without any issues related to deformation. They’ve maintained their shape and effectiveness throughout regular use, making them a reliable solution for enhancing printer stability.

Este diseño está pensado específicamente para reducir las vibraciones en el eje Y, particularmente en la cama, que es la que lleva mayor inercia y tiende a resonar a frecuencias armónicas más altas. En mis pruebas utilizando Klipper y un sensor ADXL345, he podido lograr aceleraciones más altas gracias a estos pies, lo que los convierte en una mejora crucial para impresoras 3D.

Necesitarás imprimir dos pies delanteros y dos pies traseros. Uno de los pies traseros debe espejarse en el slicer para asegurar que el recorte se alinee correctamente con la protuberancia en la base de la impresora. Orientación y colocación de soportes recomendadas en fotos.

Yo imprimí estos pies en PLA a una altura de capa de 0,32 mm, con 4 paredes y 30% de relleno. Los pegué con cinta doble faz de la más fina que encontré, pero cualquiera debería funcionar bien. Los he estado utilizando durante varios meses sin problemas de deformación. Han mantenido su forma y efectividad durante un uso regular, lo que los convierte en una solución confiable para mejorar la estabilidad de la impresora.


Analisis:

Without feets / Sin pies:


With feets / Con pies:

Tagi