1 / 4
FPV Drone Propeller protective case
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple case to protect your propellers (this is for a 5 inch drone). It fits a 3 blade propeller (120 degrees angle between each of them)
The case has a lid that can be clipped on top (sand a little bit the corners for a nice fit)
You can go fancy and add a hinge or drill a hole at the top to add something to lift the lid…I personally don't need it…but you might (everyone is different)
I can fit 6 or 7 props per case, you can make it taller of course depending on what you need.
- Made out of PLA (cheapest and simplest to print)
- 210 degrees
- No support
- Took 45 min for both prints