Toyota MR2 SW20 Cabin Window Vent
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement cabin pressure window vent on 2nd generation MR2s designed to mimic the original factory vents
- Ocena
- 0 / 5
- Polubienia
- 25
- Pobrania
- 250
- Wydruki
- 0
- Wyświetlenia
- 1058
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
DESCRIPTION:
I made this to be as accurate of a replacement for the original window vents as possible maintaining both the aesthetic and functionality while ensuring it had 3D printability. The original vents are designed with rubber flaps behind the vents to allow positive pressure (I.E. from closing the doors) to evacuate from the cabin while preventing water from getting inside. To mimic this I designed the louvres to prevent water from getting into the cabin while allowing air to escape and angled in such a way that they do not require supports.
I also created a version with MR2 text debossed on the vent face.
PRINT INSTRUCTIONS:
Strongly recommended to use a UV-stable/resistant material such as ASA. PETG not recommended as it will likely warp during hot summers.
Print this with the face of the vent facing down. Supports are only needed for the screw holes due to the countersinks; do not support the vent louvres.
This uses the 3 factory screws that sit behind the original vent holding the window trim in place.