Orion Blasters Dan Pistol (BETA) Looooong Slide Auto Return Extension + SCAR cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adds an auto slide return function to the Dan Pistol and covers an optional scar barrel.
- Ocena
- 0 / 5
- Polubienia
- 61
- Pobrania
- 78
- Wydruki
- 0
- Wyświetlenia
- 1778
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Adds an auto slide return to the front of the muzzle. This is designed with low hardware in mind. Requires 1 spring from a Retaliator or equivalent Nerf blaster, and 4 screws. I used m3x8 machine thread screws, but coarse thread will work, and I have tested 4-40 screws and they will work.
I recommend adding a sheet of craft foam between where “scar barrel cover” and “return spring muzzle” rest while the blaster is unprimed. This will reduce the force applied from the slide return.
Recommended scar barrel: https://www.thingiverse.com/thing:5174583 or the worker injection molded scar.
Print Settings that I used:
4 walls
20% infill
5mm outer brim
tree supports
inland ABS orange and sparkle purple
Print orientation of new parts:
Extended front frame: same as normal
scar barrel cover: bottom facing down (screw holes facing plate)
return spring rest front: bottom facing down (rail slot facing plate)
return spring muzzle: catch facing side pointed down + 15 degree tilt (tilt is optional, meant for strength)
Build guide:
- Assemble Dan Pistol as normal but substitute“extended front frame” and “return spring muzzle” in the build.
- Apply lubricant on all moving parts. Apply some to the rail on “scar barrel cover”, the post on “return spring muzzle”, and the bars contacting the sides of the Dan Pistol.
- Slide on “scar barrel cover” over the post in “return spring muzzle” and onto the extension of “extended front frame”.
- Use 2 of your 4 screws to secure “scar barrel cover” onto “extended front frame”.
- Slide on the Retaliator spring or equivalent onto the post of "return spring muzzle".
- Slide the “return spring rest front” onto the rails on “scar barrel cover”.
- Screw down the “return spring rest front” with the remaining 2 screws. Screw hole closest to the muzzle/front is installed from the right, screw hole further away is installed from the left.
V1.1 update
- Increased thickness of spring rest on “scar barrel cover” - This adds more precomp to the spring and increases return reliability.
- Print angle of “scar barrel cover” should now be a 45 degree angle muzzle facing up to increase strength of both the screw holes and the spring rest. Not friendly to print if your support settings are not dialed in.
V 1.2 update
- increased diameter of hole for “scar barrel cover” to allow for worker scars more easily.