1 / 4
Prusa MINI Enclosure Old PSU with Add on PSU holder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Add on PSU on top of Prusa MINI Old PSU V0(I don't have new PSU sorry_(:з) L)_) connector pointing out.
- Ocena
- 4 / 5
- Polubienia
- 6
- Pobrania
- 48
- Wydruki
- 1
- Wyświetlenia
- 301
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 1) (Komentarze: 4)Remiksy (1)Kolekcje (21)Powiązane

Size:
133mm * 45mm * 160mm ±
Weight:
90g± 30m±
Slicer setting:
- Layer height 0.1-0.2
- Filament PETG(or any)
- Nozzle 0.4mm
- NO support💢, NO brim💢
- Infill 15%
- Orientation as picture
Prepare(reuse or found in spare):
- M3x8 screw (3x)
- M3n nut (3x)
- Zip-tie/Fastening tape/Cable tie (1x optional)
- Screwdriver(\_(ツ)_/you need it believe me)

Step:
- Use one M3 screw, insert it from the back side of the PSU holder to help you insert M3n nuts into each slot, then unscrew it.
- Disconnect printer and move printer out(💀I know its pain).
- Release feet bracket so you can insert old PSU in the holder later(if you left the cable outside the enclosure then you can skip this step).

- Release the right side panel(Red arrow pointing) by removing all Nylon rivets and unscrewing M3s(if you are using Transport handle https://www.printables.com/model/921096-mini-enclosure-printable-parts/files Files>Model files>Other) on the right side.
- Simple push Nylon rivets tip from inside, once pop out pull from outside and keep push from inside.

- Move to the back panel and check the bottom left corner.
- Remove Nylon rivets at marked locations.

- Insert Add on PSU on the small slot, push it all the way to the end.
- Put the Add on PSU wire into the slot at the back of PSU holder(💀do not over bended PSU cable).

- From the inside of the enclosure, insert one M3x8 screws through the top cut-outs(green mark).
- Attach the PSU on the screw
- Secure the screw, and make sure the PSU holder can still rotate freely.

- Now check the bottom right cut-outs(green mark) and line up with PSU holder M3 slot.
- Insert second M3x8 from the inside of the enclosure.
- Make sure add on PSU wire is inside slot.
- Secure both screws.

- Insert old PSU, push it all the way to the end.

- Insert last M3x8 screw from inside and secure it(🚩it will touch old PSU a bit so do not over tight).
- (optional)Tie PSU cable at the bottom of PSU holder(I prefer put all inside enclosure and tie PSU cable inside).
- Put the right side panel back and insert Nylon rivets and M3s(if you are using Transport handle).
- Put printer back and connect the PSU