1 / 3
Prusa XL Enclosure TPU Door Seal — zdjęcie 1
1 / 3

Prusa XL Enclosure TPU Door Seal

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A thing to help keep your XL cosy.

Ocena
4,875 / 5
Polubienia
102
Pobrania
359
Wydruki
8
Wyświetlenia
2445
Oceny
8

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

🟩 🟦 🟦 🟪 🟥 🟧 🟨

This is a door seal to help keep your XL enclosure up to temperature when printing engineering plastics, intended to be printed in TPU.

There is also an optional heat shield that covers most of the TPU on the inside to protect it from heat, except for the extremities near the edges. This should be printed in something heat resistant like polycarbonate or PA6.

There are four versions of the TPU seal:

  • Two are split up to print on smaller printers ahead of owning an XL, and the other two are one piece models printable diagonally on the XL print bed

  • One of each of the above variants are slightly wider, to provide a better seal (which is what you want, right?) but needs to be closed more carefully.

  • There is a heat shield to match the thinner/wider variants.

You will need to replace the M4 screws with M4x16 ones with washers ideally to fit the extra 4mm used up by the model on the inside and outside. If you are using the heat shield you will need two M4x12 screws to replace the uppermost screws.

Note the shorter pieces of the heat shield have tiny supports to remove from the ends that mate with the central part. Remember that the handle is not connected to the frame and it will fall off when you remove the screws if you are not careful. 

If you enclose your printer too much and run it too hot, you may cause damage that may not be covered under warranty. Monitor the temperature and do not let it get too hot.

If you like my designs or find them useful it would be great if you can support me by joining my club on Printables for at least a month, which gives you access to various extra models for the duration of membership. Another alternative is to buy me a coffee over at ko-fi via this link. Thank you!

🟩 🟦 🟦 🟪 🟥 🟧 🟨

 

Tagi