SpeedyBee Bee35 compatible GPS mount for WS-M181 GPS
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A GPS mount for Walksnail WS-M181 GPS and compass module, and most likely other 18x18mm modules, for SpeedyBee drones
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 137
- Wydruki
- 0
- Wyświetlenia
- 532
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My SpeedyBee Bee35 came with a GPS mount TPU part for a smaller (I think 121) GPS module. I needed something slightly bigger, that also fits the specific connector geometry of the Walksnail WS-M181 GPS and compass module. In addition, I designed it so that it pushes the compass module slightly further away from the battery connector / battery / VTx antenna / motors, hopefully it will reduce some potential interference.
This mounts to the Bee35 antenna TPU using 2 M2 self-tapping screws, so the hole is there just to make attaching easier, and isn't designed to fit any specific screw size.
I printed it from Polypropylene which I think is a great material for drone accessories, but you can probably also print from TPU or maybe even PETG.
You probably need some support to print this, depending on the material - but you can also try without any support. I printed as shown in the image, on the rear end with organic support for the front (top) only.
FreeCAD source file is provided if you want to remix this for other drones / GPS modules, or to push the GPS module further out back.