Ender 3 V3 KE Side Spool Filament Guide
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Filament guide brackets with modular clips for PTFE tubes
- Ocena
- 5 / 5
- Polubienia
- 51
- Pobrania
- 294
- Wydruki
- 3
- Wyświetlenia
- 2607
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I use a side spool holder and I didn't like the filament guides I found online, so I made my own. The two brackets, one for the side, and one to go above the run-out sensor, take one of two modular pieces that can either hold this Amazon PTFE Push Connector, or one that you push the PTFE tube into that works better than I expected and would have been the only one I made if I didn't already have the push connectors.
I have also included the models without the modular shape on them, along with a blank module if you want to design your own clips or brackets and use either the clips, or the brackets with your own designs.
There are also two side brackets and the one with “LED” on it is for if you have the LED light bar like I do.
I printed everything with PETG and tweaked the tolerances until the two-piece bracket above the run-out sensor pressed together securely without too much force.