1 / 7
Ender 3 V3 SE Hotend (MK4S like) + 5050 fan + V6 hblock + LED (optional) — zdjęcie 1
1 / 7

Ender 3 V3 SE Hotend (MK4S like) + 5050 fan + V6 hblock + LED (optional)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

5050/15 fan, Optim. fan duct, CR-Touch Positioner, Optional LED, V6 heat Block. Better performance and compact layout.

Ocena
0 / 5
Polubienia
19
Pobrania
76
Wydruki
0
Wyświetlenia
1119
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This MOD  was inspired in the FAN layout of the new MK4S. Uses a case for 5050 fan, and an optimized fan duct. Also replaces the original ender3v3 Heatblock (very poor quality) for an V6 heatblock, and V6 tips (clone).

  • All models can be printed in PLA (recommend PETG), except for fan duct that needs to be printed in PETG or ASA/ABS/PC (better with these materials).
  • Models need minimum supports, specialy in headscrew holes and fan duct.
  • This MOD requires a couple of M3 screws, M3X8 (7 pcs) or M3X10 (7 pcs)
  • The LED (6mm LED) is an optional add. For instaling it, you need to put it in series with the heatsink fan. This reduces the noise it makes, and feeds the LED with the correct amount of energy (~3.5V/~20ma).

**The original Block can be used adjusting the fan height

Tagi