Accessories for the Fimi Manta

Here are the parts I designed and 3d printed for my Fimi Manta rc FPV tiltrotor model.
The left and right nacelles were printed in LW-PLA and attached using strips of coloured vinyl tape.  They have good clearance around the servos and moving linkages.
The flight controller plate was used instead of the wooden one supplied in the Manta kit.  It not only mounts the flight controller but also allows a cable tie to restrain the Li-ion battery cable and the plate is firmly held in the model using a M2 screw (it goes through the “floor” of the Manta) and one of the screw surrounds.
The Li-ion Tray is also retained with a M2 screw and screw surround (in the same fashion as the FC tray) as well as locating around the main wing spar tube.  This mounts the Li-ion batery as far back as possible so that I only needed 15 grams of extra weight on the tail to achieve the correct C0G.  This tray was printed using PLA+ for strenght.
The GPS support mounts a Matek M10Q-5883 GPS and Compass module as far from the hatch magnets as practical.  Again it mounts using an M2 screw and the GPS Nut Plate inside the Manta fueslage.  The Matek module is retained in the PLA+ print using a small amount of epoxy adhesive and the wires route through the mount and original hole in the fuselage.
Finally there are mounting brackets for the Walksnail Avatar module and camera.  These were printed using PETG (for heat resistance) and the Avatar module plate is retained using a M2 screw and the Screw Plate that fits snugly under the “foam” camera front moulding supplied with the Manta kit.