captureKNX SSD Case for Tijl KNX Hat
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Raspberry Pi project that will capture all KNX telegrams to InfluxDB that you can query from a browser.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 141
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
See GitHub for details of the project.
This version of the case is for a Raspberry Pi -5 and SSD with the Tijl KNX hat (Pictured below). If you are using the Weinzierl KNX Hat, you will need to print this case.
You will also need a 30mm fan with a 4 pin JST connector and heatsink for cooling. This plugs into the fan socket on the Pi.
The design uses a Finglonger to extend the power button to the outside of the case. You will probably need to clean up the hole for it using a 3mm drill bit. Don't forget to insert the Finglonger before you screw in the Pi.
You can also extend the LED to the outside by using a short length of clear 1.75mm filament to create a light-pipe. PETG is the best for this, but PLA will also work.
The lid has been supplied with inlays to print the “captureKNX” label. If you don’t need this, just delete it when slicing.
You may be able to get away with printing the lid without supports. It worked for me, but it’s a bit neater with supports in the area around the KNX connector. No supports are needed for the base.