R36s Console grill / vent
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cover which replaces the sticker on the back of the console, leaving a vent for heat from the CPU.
- Ocena
- 0 / 5
- Polubienia
- 32
- Pobrania
- 173
- Wydruki
- 1
- Wyświetlenia
- 2919
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a simple heat vent for if you feel the need to put heatsinks on your R36S console and feel you need more airflow.
Includes a simple jig for marking a hole for the air. Or you could just drill a whole bunch of holes, up yo you.
Tools you may want / need…
- Drill,
- Flat file,
- Marker pen / pen / pencil,
- Stanley knife / box cutter / similar,
- Some form of saw you can remove the blade (e.g. junior hacksaw or coping saw with suitable blade).
- A suitable glue, superglue (CA glue or Cyanoacrylate glue).
Instructions…
- Remove sticker,
- Place jig on back of console,
- Mark interior of jig with marker / pen of some kind,
- Drill holes in corners or around markings (always drill with a piece of wood behind to prevent cracking & start with a small drill bit),
- If you drilled holes in cornders, you can now use saw by disconnecting blade, passing through hole and reataching, otherwise ignore,
- Once hole cut, remove saw, if necessary.
- Use file to smooth out the edges of the newly cut / drilled hole,
- Once the hole is filed suitably and no plastic is visible through the hexagons, move to gluing on the hexagon grid vent cover.
- When placing on the vent cover, note position of the angled corner.
I hope this works for someone, I haven't honestly decided if I need to do this yet (mostly because I don't want to drill my R36s). But I have printed the parts. I put on the heatsinks as I had them already (they're Pi 2/3/3B+ RAM heatsink (as RAM was on the bottom of the board and still needd to fit in a case)).
These are stupid quick prints BTW, about 30 minutes total at 60mm/s, not counting heating and cooling time.
Please let me know if you need any further information / advice / changes to file.
Thanks to @johnny_668460 for https://www.printables.com/model/858062-r36s-console-nintendo-logo-for-backplate which confirmed my dimensions.
Yes, I put on the shoulder buttons, found here… https://www.printables.com/model/794361-r36s-shoulder-buttons (not the original designer, just re-uploaded).
And remember… Hegagons are the bestagons.