multifunctional samsung a 35 heavy duty case V3

this is a phone case i made for the samsung a35, the case is strong and features a built in card holder, that is held in with a clip. to assemble the case you will need some thread inserts, i used m2 inserts. the holes for m2 inserts are also already made into the model. Any small changes i make or would like to make are uploaded as soon as possible.

if you prefer the v2 pattern over v3 you can switch them out, as they are basically the same with some minor tweaks, you will then also have to use the v2 tray

print settings are intirey your on preference. i printed these with cr petg and 0,2 layer height and around 5-20% infill. lower infill will give more flex higher infill is more rigid but might cause damage to your phone rather than the case

Supports:

Top:yes

Bottom: no

Card tray: no

Buttons: no

Changes to v2

Closed the back of the case for better looks and protection

Sloped the sides so you can set it down

Reduced thickness

Rounded off edges to make it appear less blocky

Increased hole size for the flashlight

Made the overall design smoother

Out now,

Changes to v3

changed the pattern on the back to be entirely flush

improved the way the card holder sits on its guide rails

improved flushness for some other parts (card holder, mainly)

improved fitment for both screws and thread inserts

fixed an issue where the cards in the holder would get stuck between the case and the holder itself