Quickdraw probe servo powered dock for 3030 Extrusion (for HevORT)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Servo powered retractable dock for original quickdraw probe (by AnnexEngineering) to be mounted below a 3030 extrusion.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 284
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I created this for my HevORT (see hevort.com) for the Goliath Short with adapted Tentacool. It is mounted below a 3030 extrusion. Height can be adjusted in a range of 5mm. A 5mm metal rod is used to join the parts, cause i dont like printed joints ^^
Non-printed parts:
- 5mm Metal rod, 40mm length
- Magnets D6x3 (8 Pcs)
- D2F switch (D2F-5 is recommended)
- MG90S Servo
- Ruthex 3mm Brass Inserts (4 Pcs)
- M3x12 screws (4 Pcs)
- M3x20/22/25 screws (2 Pcs)
Probe files are included, but it is the Annex-Engineering Quickdraw without any changes:
https://github.com/Annex-Engineering/Quickdraw_Probe
The longer M3 screws are inserted into the probe dock to increase stability. This part of the Dock is also identical to the original from AnnexEngineering.
No support needed for any of the parts. The "mount" may be supported in the area, where the servo sits, depending on your printer's bridge capability. There are 0,8mm clearance for sag.
>> Step & SLDPRT files follow soon <<