Weighted Companion Stylus
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
EMR stylus which looks like a #2 wooden pencil
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 248
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted an EMR stylus for my phone (S21 Ultra), but I also wanted it to look like an old-school wooden pencil. Staedtler has a few options, but I wasn't fully satisfied with them. Primarily, I wanted something heavier, and thicker, and for it to look like a pencil. This satisfies all of that, aside from the color, which is just paint. The weight comes from a 5mmx100mm brass rod
Printing
the fine details of this model almost inherently require it be printed on an SLA machine or something similar. I chose to have it printed in an engineering resin (mostly for peace of mind) by a service because my resin printer is not up to the task, aside from prototypes. One thing i would make sure of is to NOT have support inside either of the holes. But, if you must, a long 5-5.5mm or 13/64-7/32 drill bit can clean up the “eraser” hole, and a 3.8-4mm or a 5/32" drill bit can clean up the EMR tip hole.
Non-Printed Parts
Brass Rod
I used one of these. If you want a lighter one, you could omit the rod, use a less-dense material (like aluminum or plastic), or use a shorter rod. I wouldn't omit the rod, because the walls are fairly thin, and they would be unsupported.
EMR Donor Pencil
I used this product, because it was cheaper than the other options, and I theoretically got 2 chances to get a functional tip out of it. The “eraser” end is hard to get out intact, but I'm sure someone else could do it. Obviously, you will have to destroy it to get the tip out.
Assembly
I did it in the following order:
- print the parts, cleaning out the holes, if needed
- glue in the brass rod
- glue in the “eraser” plug.
- you may have to shorten the plug to get a flush fit. just sand the cylinder end down until it fits.
- do any surface sanding you deem necessary. (most paint wont cover divots and such)
- prime and paint
- glue in the tip (optional, if its a snug fit on its own)
I found that inserting a drill bit or needle file into the empty tip provided a good way to hold it while painting and drying.