Stretchy, Slinky Pumpkin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Kann ohne stützen gedruckt werden.
- Ocena
- 0 / 5
- Polubienia
- 87
- Pobrania
- 272
- Wydruki
- 1
- Wyświetlenia
- 1317
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Autumn & Halloween
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
3D PRINTING SETTINGS: PLA works best.
Layer height 0.2 mm
15 % filling
No supports required
The slicer shows a lot of warnings, please ignore that. The program detects the distance between the individual layers. This "space" is wanted and necessary to separate the layers afterwards. It prints well even without supports.
After the pumpkin is printed, the layers are separated from each other with a knife or scalpel.
Note: The layers are best separated from each other immediately after printing, if you missed this, let it overflow with hot water.
If the layers are far apart after removing as in the picture below, squeeze the model firmly and pour hot water over it. (Attention, not too hot, otherwise you will burn your fingers) To speed up the process, pour cold water over it.