Aluminum extrusion smartphone stand.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Smartphone stand for mounting on aluminum extrusion.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 106
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
Mounting stand for holding a smartphone on aluminum extrusion. Designed to fit 1515, 1530, 3030, etc. extrusion. Likely works for 4040/4080/8080 as well, but I have not tested it. Holds the phone at about a 30° laid back angle. 110mm high and 12mm deep, which is enough to hold most cell phones in a case, including the iPhone 15 Pro Max. iPhone X is pictured in photos.
Not all aluminum extrusion profiles are the same, so the fit may be looser or tighter depending on the exact manufacturer and profile you have. In my testing, printing at 100% size resulted in a mount that easily fit, but was a bit loose. Printing at 102% resulted in a very snug fit. I recommend sizing to 101 or 102% and printing the first centimeter or so of the model and then test fitting your particular extrusion. Then you can size up or down for your preferred fit and print the entire model.
My pictured version was printed in Overture Matte Black PLA on a Bambu Labs P1S with a .6mm nozzle using the “Extra Draft” profile (.28mm layer height).