Tolerance Tester Gridfinity Bin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple 5x1x4 Gridfinity bin to store your tolerance tester. Not stackable because I didn't need stackability, but a stackable one would be a good idea because you should probably print a tester for each filament you use (that you need dimensional accuracy for).
Important caveat: While I've selected the given model as the remix, technically this is built around the tolerance tester stl file that's provided in the I Like To Make Stuff Fusion 360 class. I believe it's the same (or at least a very similar) tester, but I'm not 100% sure.
In any case, it just loosely holds your tolerance tester. Also gives it a fancy label since there was so much empty space. Nothing else to it really.
Print Settings:
Print however you like to print gridfinity boxes, but keep in mind this one has a bunch of solid space. For me:
- Infill: 8% Gyroid
- Material: PLA Matte
- .2mm layer height
- No supports
- Defaults are fine.
You might consider an infill with 10% lightning though, to reduce plastic usage and print time further. I've started using that approach on some of my more recent prints.