1 / 1
Clamping rod-cradle for The 100 v1.1 - Remix — zdjęcie 1

Clamping rod-cradle for The 100 v1.1 - Remix

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of the modified rod-cradle that allows each bearing to be clamped separately while preventing them from slipping

Ocena
0 / 5
Polubienia
0
Pobrania
17
Wydruki
0
Wyświetlenia
114
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The original design is great for adjusting the pressure on the drylins, but the perfect “stiction” for the ones that I have were easily slipping off the rod-cradle (possibly also caused by me printing them on the side rather than on the back), and tightening the screws more resulted in a lot of layer shifting on the diagonals, as you can see bellow.

This remix adds a lip around the bearing holes to prevent this issue. Made specifically for the RJ4JP-01-08 drylins, which is 24mm wide.

BOM

Just like the original design, it requires an additional:

  • 8x M3 heat inserts
  • 8x M3x12 screws

A non-permanent threadlock solution (like the Loctite 242 and possibly the 222 too) is also highly recommended to prevent the screws from loosing up over time due to the printer vibrations.

Print settings

Print the parts on the given orientation (with them lying on the back), so support is only added to the countersunk holes and not to the lips.

Tip

If you already printed the models from @idconvict, you can just print the two back parts to reduce the amount of work involved on the assembly.

Tagi