1 / 1
PLC Bracket
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
Bracket to support a PLC, either Mitsubishi Q-Series or IQ-R Series or Schneider M580 or M340. You need to mirror the files for the other bracket.
The V6 works fine for PSU side of both PLC, but due to SE alignment the V7 works best at other end. The V6 has the hole down the middle, while V7 is slightly offset.
These where designed to go in a Kallax 2 on top of each other, therefore fitting in 4 per cell.
These are designed as development units, and not for install in actual location.
You will need 4 x 3m bolts and nuts etc. The length of the bolt depends on the platform.