3DQF spoked spool ring - low friction and narrow brim
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A low friction spool ring using less than 50gms of material for two off.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 82
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a low friction spool ring for using with my 3DQF PLA filament that was both strong and as narrow as I could get away with.
It uses an inner (37mm diameter) and outer (82mm) rim and has four spokes for additional strength (see the STL file for a better look at the design) and to keep the amount of required filament and print time down.
The inner rim fits perfectly over my Creality Ender 3V3SE/KE spool holders but should fit over similar sized holders.
Print using 2 perimeters and 20% infill (I used cross-hatch).
Overall material used is just under 50gms for a set of two and on my Bambu Lab A1 Mini it takes 1 Hour 21 Minutes (including ABL) to print.
I've attached the STL file, the FreeCAD file and the 3MF & GCODE files generated on my Bambu Lab A1 Mini.