1 / 5
Goggles X Front Plates
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Printed tilted forward 45° with organic support on build plate only and at a 2.8mm layer height.
Use M2 screws or e6000 to attach to the front of your Goggles X.
- The VRX cover uses an iFlightVRX, Runcam Cam Mini DVR, 20x20x6mm 2wire 5v Fan. From the NFG bin I found momentary button, a SPDT switch and a BT2.0 connector
- The Patch Cover has cut outs on the top and bottom of the cover for the antenna wires and the patches are e6000'd in place just on the edges. It has an acute angle of 35° providing a larger spread then Walksnail's original 20°. (See photos for visual representation of this spread and overlap)
- The Basic Cover has no cutouts, has about a ½" (13mm) depth, and is for you to DIY with on the bench or in a modeling program. It uses m2x16-18mm screws.