Shark IQ Robot Vacuum Front Wheel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement Front Wheel for many Shark robot vacuums
- Ocena
- 5 / 5
- Polubienia
- 23
- Pobrania
- 89
- Wydruki
- 0
- Wyświetlenia
- 562
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Has the rubber delaminated on your shark vacuum front wheel? Does you little robot lurch and bump around and try to take his little docking station away with him? Well that means you need a new front wheel, that you can't buy.
Purchased parts
4mm x 30mm long dowel pin
Print in TPU 0.2mm layer height, 3 walls minimal infill and minimal for quality top and bottom surfaces. After its printed the dowel should spin freely in the part but not slop, if its too loose increase your extrusion multiplier or your hole size correction and try again, if its too tight you can slowly open it up with a 3/16" drill bit.