Raspberry Pi Zero and Pi Sugar Battery Case - Open Data Collection Project
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A case for the Raspberry Pi Zero and Pi Sugar Battery module for the Open Data Collection Project
- Ocena
- 1 / 5
- Polubienia
- 6
- Pobrania
- 150
- Wydruki
- 1
- Wyświetlenia
- 923
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Share Alike
This Raspberry Pi Zero and Pi Sugar Battery case is part of the Raspberry Pi-based open-source data collection project. More information can be found at the Github Repository link below:
https://github.com/hleve/rpi_data_collection
This module is intended to act as the main computing module and will collect data via sensor modules connected through the GPIO pins. In its current state, this module is intended to be mounted to the brim of a hat via the cap with a clip. Alternatively, the module can be mounted to a different surface using the plain cap. The cap with GPIO pin holes is sized for Dupont wires to attach to the first five GPIO and can be modified for different pin locations.
The Raspberry Pi Zero model can be found here: https://www.printables.com/model/988094-raspberry-pi-zero-2-w
This project can be printed in PLA, but for better UV resistance for outdoor use, ASA is the recommended material.
Note: To install the Raspberry Pi Zero and PiSugar battery in the housing, first detach the RPi and the battery, then place the Rpi in the top of the case, sitting on the shelf pieces, then add the battery from the bottom and screw together to sandwich the shelf pieces.