E-Series Fixture Plates and Straps
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
M5-based Fixture Plate and Stap-Clamp system
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 90
- Wydruki
- 0
- Wyświetlenia
- 643
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
Not much documentation on this one except to say that you'll need M5 hardware at whatever length you want for the strap clamps.
The threaded Inserts in the fixture plates are meant to be 10mm
The Eccentric Nut (the Mitey-Bite inspired one) uses an M5 caphead screw. Best bet is to use 8mm or 10mm length
I recommend printing the Strap Clamps in ABS or PETG. I added the “teeth” of the strap clamps as separate files because I chose to print them in resin. I got away with printing the fixture plates in PLA without issue (I opted orient it face-down because I like the texture).
For the straps, they are named for their range of Travel. The “J” variants have room for an 8mm M5 insert so you can thread in a “jack” bolt for a fulcrum. You can use whatever hardware you want for the down-force bolt (except a countersunk screw), but for the Jack Screw I actually like using what I've found as “Furniture Bolts” - they have a wide head that serve nicely as a “foot”
On the plates themselves there are 4 countersunk M4 bolt holes. Those are so you can fit it into the E-Series Mount here (https://www.printables.com/model/992148-d-series-mounts), which can then be used in the D-series Ball Vise.