1 / 7
Halloween Bat with Glowing Eyes (5mm LEDs and AA/AAA batteries) — zdjęcie 1
1 / 7

Halloween Bat with Glowing Eyes (5mm LEDs and AA/AAA batteries)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A quick and easy project to make decorative bats for Halloween with "glowing" LED eyes

Ocena
0 / 5
Polubienia
3
Pobrania
32
Wydruki
0
Wyświetlenia
197
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This print is pretty simple but works well. It has two parts: the bat + a cover to contain the wiring etc. Printing using pretty much any settings should be fine, but the design is intended for 0.2mm layer height.

Components needed:

  • 2x AA or AAA batteries
  • 1x 100 ohm resistor (or something closeish to that - less resistance leads to brighter lights but less battery life, although in my testing they'll last a couple days even at 10 ohms.
  • 2x 5mm LEDs
  • Some wire + solder

To assemble: wire the two positive ends of the LEDs (the longer poles) to the resistor (this is important - without a resistor you'll probably burn out the LEDs), then the resistor to a wire which is wrapped around one of the ends of the battery holder. Then wire the negative terminals to a wire which is wrapped around the other end of the battery holder. Done!

I put a couple holes on the tips of the wings to make them easy to hang up, but if someone wants an upload with no holes just leave me a comment and I'll make the edits.

Happy Halloween!

 

Tagi