Han Solo Blaster DL-44 - Scope, Screw & Sight Leaf Mods
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The mod contains parts for https://www.thingiverse.com/thing:1915956: A remix of the crossbar thumbnuts that now use…
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 77
- Wydruki
- 0
- Wyświetlenia
- 1346
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The mod contains parts for https://www.thingiverse.com/thing:1915956:
- A remix of the crossbar thumbnuts that now use M4 hex-head screws in order to achieve better grip and allow assembly/disassembly.
- Improved version of the scope windage knob and scope windage mount that now look much closer to the original part.
- The hammer mechanism is modified to be able to fit a bolt.
- The crossbar contains a place for an M4 hex-head bolt on the back at the middle hole.
Sight leaf clip that prevents sight leaf from falling out, while allowing it to move up and down. Required:
3x M4 hex-head screws with thin head (3mm), overall length 20mm;
- 3x M4 hex-head bolts, thin head (2-3mm)
Gel Super-Glue UPDATES:
2018-06-29 - Fixed Scope Windage KnobPrint Settings
Printer Brand:
Prusa
Printer:
Prusa Mk2
No
Resolution:
0.10
20%
Notes:
Use supports for Part 32 (hammer mechanism).
Mounting the Screws
Insert the screws heads in the printed thumbscrews, make sure they are all the way in (use a vice if required) and glue them with a few drops of super-glue.
If you need to use a vice, you must first screw a bolt, because you will most likely damage the threads, and unscrewing a bolt that is already on the screw will be the best way to fix it.Middle thumbnut consists of 3 parts, while the two side thumbnuts consist of 2 parts.
Fitting the Bolts
You can print the modified crossbar that has a place for fitting a bolt, but you can also modify your existing part by expanding the middle hole with a 6.8-7 mm drill bitbut not all the way - just 3 mm in depth. Then use a vice to force a bolt in.
For the other two bolts you can just put them on the inside of the gun and wind them on the screws.
DO NOT OVER-TIGHTEN!
Refactored Scope Windage Knob & Mount
New scope knob and mount are refactored to match the original. Two screw heads are added on the top, together with 8 hairlines. The mount is redesigned from the scratch, according to the many available photos of the original scope.
Before painting, it is advisable to sand the parts. Painted using golden Revel Model Paint 321 94 and weathered using black acrylic paint.
Sight Leaf Clip
The clip prevents sight leaf from falling out, while allowing it to rotate with a reasonable amount of force.
The clip should tightly fit its place. If it's too tight, use some sand paper to sand it down. If it's too loose, you can either slightly increase its size before the print, or you can spray some paint to gain thickness. However, before mounting the leaf, first try if it fits without the sight leaf, because once mounted, it will be hard to remove.
To finalize the assembly, first mount the sight leaf, then slide the clip in. Use a flat screwdriver to force it in place.
Category: Toys & Games