Canik TP9 Base Plate with Mantis Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A base plate for the Cannik TP9 with an adapter for the Mantis X System.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 675
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Public Domain
An M3 x 4mm L x 5mm heat set insert, and a M3x8mm screw is required. This locks the magazine in place. Otherwise it tends to slip off when you slam it home. The outside profile of the rail on the bottom is technically Picatinny, but I opted for a form fitting cutout for the Mantis X tab. This was intended to minimize play. The ‘wings’ on the side are intended to provide a little extra grip, and line up with the recess on the base of the TP9SFX.
Post print Changes
After printing the model I made a few changes before posting. These were minor tweaks, and hopefully they only have a positive impact.
- I reduced the diameter of the heat set insert hole from 4.6mm to 4.5mm. Mine was a little loose, so I reinforced with super glue.
- Thickened inside of the base plate from 4mm to 5mm. The heat set insert is 4mm long, so mine is 1mm proud, which is only an aesthetic problem.
- Added a chamfer to either end of the rail to make putting the mantis on a little easier.
Print Settings
- Overture Matte PLA
- PLA probably isn't the best if you plan on dropping it during an out of battery reload, but that is probably bad for the mantis anyway.
- 0.4mm nozzle, 0.1mm layer thickness
- The low layer height makes the bridges and overhangs cleaner. This is particularly important
- 10mm brim to address adhesion issues.
- 5 perimeters, 5 top/bottom layers.
- Extra layers are required for the heat set insert to work properly.
- 30 degree organic supports. The last few layers of the curve on the front of the magazine have a steep overhang. This is probably unnecessary with a 0.1mm layer thickness.