Biggs D&D Battle Box - Compact - Stone, Wood, Dragonscale
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Even more Compact DND Box with Dice Tower and Spell Slots, Death Saves, Hit Points, Inspiration, and Misc trackers
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 75
- Wydruki
- 1
- Wyświetlenia
- 588
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
More compact version of my compact dice boxes.
No Magnets required for this one.
The lid slides into the top of the box and is held in place with a friction latch that you have to lift up to release.
The mini dice tower can be used in the slot it is stored in or outside of the box.
The peg compartment tapers up for ease of removal.
Comes in three flavors:
Stone/Brick
Dragon Scale
Wood
I have also included three lid designs for each of the boxes:
Plain
DND Logo with Border
DND Logo with fancy border.
I printed the ones pictured at 0.2mm layer height.
Dimensions:
- Overall dimensions are 124mm x 122mm x 37mm
- Dice Box - Has compartments for Dice, MiniFigs, Pegs, and a Dice Tray (small) / Dice tower
Dice Box Dimensions: 124mm x 122mm x 37mm
Internal dimensions are:
Dice Compartment - 65mm x 65mm x 35mm
Dice Tray/Tower Tray - 93mm x 55.5mm x 35mm
MiniFig Compartment - 65mm x 49mm x 35mm
Peg Compartment - 50.5mm (Tapers up after 23.5) x 21mm x 35mm
- Dice Tower Dimensions: 88mm x 50mm x 30mm
- Lid/Tracker Dimensions: 121mm x 118.75mm x 6mm
Spell Slots - Levels 1 thru 9
Death Saves
Hit Points - Counters 1 - 999
Inspiration - 6 slots for those who use more than one point
Misc - 10 slots for tracking things like luck, tokens, etc.
- Lid/Logo Printing Instructions:
Print the Logo first (It should look upside down and backwards)
Center the Logo on the build plate (very important for alignment with lid) - your slicer should have an option to center the object
I suggest printing this slowly and do Not used a Brim as you will be leaving it on the build plate, I printed mine at 30mm/s with a Skirt that was removed after printing finished
It should only be 1 layer thick if printing at .2mm layer height
If printing at .2mm layer height you can turn on Ironing to make sure that the layer looks a bit better
Leave Logo and border design on the build plate and remove any wipe and/or skirt you have printed
Print the Lid
Center the Lid on the build plate (very important for alignment with logo) - your slicer should have an option to center the object
Print first layer very slowly for Wood Logos or use glue. I printed mine at 15mm/s. I had issues with the sides pealing up that may have just been attributed to the wood filament that I was using