Rubbermaid Roughneck Storage Box Latch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement latch for large Rubbermaid Roughneck Storage Box.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 202
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
I was recently gifted a large Rubbermaid Roughneck storage box. It was missing a latch, so I popped into Fusion 360 and modeled a replacement. So far, it works at least as well as the other three originals.
Currently, I printed this in PLA at 15% infill. This will probably be fine if you need one and it's going to be stored inside. However, if you are going to store it outside in a shed, or storage unit, or use it in the back of a truck in direct sunlight, or sometyhing, you'll want to print in PETG or ASA, or something. PETG will probably be fine. Depending on your needs, you might want to boost the infill a bit for added durability, but so far in my testing, just standard 15% seems like it will work great.
I don't have any PETG at the moment, so I can't print and test and upload a profile for you in that.
Also, my printer is dialed in really well. I have it tuned to 0.06mm precision. If yours is a little looser, I have left a little bit of wiggle room in the design, if you need to scale it down any to get a better fit. In my testing on my printer in my setup in my circumstances, my design latches about the same tightness as the three originals. If your printer is tuned well, this should work well for you.
I'm a novice at design and especially using Fusion 360, so if you notice anything that needs to be fixed, let me know. :)