Dagger Display Shelf
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small hex shaped shelf to display a small, decorative dagger
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 116
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A hex shaped wall mounted display stand for a small dagger. It also includes a front part that has the flag of Nepal on it because the dagger I'm displaying is from Nepal. There is also a blank front, which you can use or modify for your purposes.
You only need to print one of each part.
Important Note: I had to make the main shelf slightly smaller to fit on the print bed of my Creality K1. So the STL for the main Shelf part is smaller. However, I did not make the STLs for the Support or Front smaller. I just shrunk them in the slicer. So for all of the parts to fit, you will need to shrink the Support and the Front to 95.93% uniformly.
A couple of other notes
- You will need supports when you print the main Shelf, to support the dagger support columns. The supports attach on the back part of the columns, so you won't be able to see the imperfections created by the supports. I used Organic Tree supports in Orca Slicer
- Be sure that you have calibrated your X-Y Hole Compensation, or the bottom guide holes for the Support may end up too small.