BTT Pi2 1.01 Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
BTT Pi2 1.01 Case
- Ocena
- 5 / 5
- Polubienia
- 28
- Pobrania
- 176
- Wydruki
- 1
- Wyświetlenia
- 975
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Remixed Raspberry Pi 4 Case for use with the new Bigtreetech Pi2. I also made a low profile DIN rail clip that uses a couple rubber bands for retention.
I used this type of M3 self tapping wood screws, I personally think they work about as well as a screw with a heat insert. I used M3x16.
The buttons are a little cumbersome to install but not to hard.
Also be careful of the heatsink placement. I would suggest to install the board into the mount then place the heatsink on, otherwise it could interfere with the mount. Once the adhesive has set it's pretty hard to remove and could result is damaging the board by ripping the processor off.